Dear all, Could you make sure that, before this powercut (thursday morning from 6.30 am), your imaging is done and that the confocals are switched off. Especially the argon lasers needs time to cool down. A power cut like this could damage the lasers! Also the internet will be switched off which would effect your saving. Thanks in advance! Greetings, Evelien From: "Christa Verplancke" <chpla@psb.vib-ugent.be> To: "research" <research@psb.vib-ugent.be> Cc: "HelpDesk" <help@psb.vib-ugent.be> Sent: Tuesday, January 30, 2018 10:10:04 AM Subject: Re: Power cut Thursday morning am in stead of pm ! BQ_BEGIN Dear all, I made a mistake in the mail below. Due to maintenance their will be a power cut Thursday morning (Feb 1st) from 6.30 am until 7.30 am max. I apologize for the confusion, Christa BQ_BEGIN From: "Christa Verplancke" <chpla@psb.ugent.be> To: research@psb.ugent.be Cc: "Helpdesk PSB" <help@psb.vib-ugent.be> Sent: Tuesday, January 30, 2018 9:53:24 AM Subject: Power cut Thursday morning BQ_END BQ_BEGIN Dear all, Due to maintenance their will be a power cut Thursday morning (Feb 1st) from 6.30 pm until 7.30 pm max. What will be off?: * lights in all TC rooms (for the day/night rooms the lights will only be switched on after the cut, not to cause extra stress to the plants by putting on the lights at 6 am for 30 min.) * all lights at the 1st floor * internet * some sockets at the 1st floor Please switch off all equipment on Wednesday evening. Regards, Christa Christa Verplancke - Logistics officer Administrative Support,General Support VIB-UGent Center for Plant Systems Biology Ghent University Technologiepark 927 - 9052 Ghent - Belgium Tel. +32(0)9 331 38 15 [ http://www.psb.ugent.be/ | www.psb.ugent.be ] BQ_END BQ_END